I've seen write ups where people removed ALL of their caps on their brand new board to put on higher quality ones to squeeze a little more OCing out of the board. unless you don't mind it being slightly messy where you can heat it up from behind and then pull the cap out the top. Didn't make it 3 years before the boards 1 by one showed up with blown caps. heatrae sadia carousel manual,heatrae sadia electric boiler manual,heatrae sadia express 7 manual,heatrae sadia fbm 25 manual,heatrae sadia fbm 50 manual,heatrae sadia fbm eco manual,heatrae sadia manual,heatrae sadia megaflo he manual. Seemed to me that every manufacturers boards had this issue, i specifically remember Gigabyte boards being VERY bad about that a good handful of years ago when we took a few clients office systems in that we had built for them. RHTXModel (link to product page for more information)Max. These were probably around the same time all of the bad caps. very unstable regardless of what was set. Shop for ENERMAX Liberty ELT500AWT 500W ATX12V Ver 2.2 AC Power Supply. made it a good 5-6 years for each board before each had the same issue, locking up at memory tests, power on issue, locking up in windows. hmmmm, now im interested in pulling them back out and doing it though. I've had issue with Caps in the past and never bothered to solder new ones onto the old boards. Wow JJC, sounds like your system got jealous of your sons new build and decided to give up on you, whats the odds.